Vygis toolbox and Vpower box

bbadministrator

INSTALLATION MANUAL FOR VygisToolbox and VPower box
(NOT valid for old sentinel dongles)

1. MOST IMPORTANT: DISCONNECT ANY BOX FROM YOUR PC !!!

2. Go to one of the automatic support areas:
http://support.vygis.net
http://vygissupport.unlock.lv

3. Download Smartcarddongle drivers for Win98 or WinXP and install (run that exe file) on your PC.

4. Connect VygisToolbox (or VPower). It will ask also for driver for the USB part (communication).

5. Download this drivers from the support area and install them.
Take care - the VygisToolboxes and Vpower boxes, using the SMALL BLACK USBox are needing on Win XP the special driver, also available there.
If they are installed properly you will see in ''Device Manager'' in the USB section, the VygisUSB2RS232 port component.

6. Download the dongle ID reader from that site, and read the dongle ID.
If you can read the dongle id then your smartcarddongle drivers are installed properly

7. SEND the Dongle ID to your reseller and he MUST send you the reg files for your order.
NOBODY except your reseller can provide this for you

AFTER YOU RECEIVE THE REG FILES FROM YOUR RESELLER:

8. Go to one of the automatic support areas:
http://support.vygis.net
http://vygissupport.unlock.lv

9. Download LG supporter software, for VygisToolbox (for VPower you have to use O2 reg file and O2 supporter software) from there and copy in a separate folder
Copy LG reg file in the same folder

10. START the LG supporter software to get access to the LG support area.

11. Download the LG software in different folders and puty a copy of the LG reg in each of this folders.

12. If you have bought extra activations or full pack, then you have more reg files like Alcatel (Full pack) , O2 (Extra payed) ..., then take from same automatic support areas, the corresponding supporter software (Ex: Alcatel supporter if you have Alcatel reg)... and you get access at that support areas and download and install this software.

13. Now your software should be installed, and the reg files copied in the corresponding folders ==> all is ready to run

Guest · Posted: Tue Sep 01, 2009 6:27 am Post subject:

i want video training of vygis box can u give me information about this?